TRANFOVIA(NINGBO) EQUIPMENT TECHNOLOGY CO.,LTD
TRANFOVIA(NINGBO) EQUIPMENT TECHNOLOGY CO.,LTD
A large generator curing oven is a purpose-built thermal system for the insulation-paint curing process of generator stators and rotors. Compared with a general industrial oven, selection is driven by very large workpiece mass and geometry, trolley stability, air-distribution uniformity, exhaust safety and the need to monitor the curing condition of expensive generator components.
The HW series is primarily used for rotor and stator insulation-paint curing in large wind-turbine generators, hydroelectric generators and steam-turbine generators. The equipment can be engineered around stationary or rotating curing requirements and is intended for large electrical-machine components where loading stability, chamber airflow and process monitoring must be considered together.
The air-duct design and balanced recirculation airflow are optimized to improve temperature uniformity across large workpieces.
The accompanying trolley can be designed for loads up to 300T, with stable travel, thermal stability and sealing around the oven interface.
According to the process, the oven can be designed as a rotating baking/curing furnace for rotor or stator rotational curing requirements.
The exhaust configuration can be engineered to discharge gases generated during insulation-varnish curing in line with the drying procedure.
An advanced heat exchanger can use exhaust hot air to preheat incoming air, improving equipment energy utilization.
Flameproof motors reduce spark generation during motor operation and support the safety design for varnish-curing conditions.
The system can use HMI + PLC control with PID temperature regulation. Options include a programmable insulation resistance tester, paperless multi-point temperature recorder and industrial computer monitoring for remote networked operation.
| Selection Item | Available / Supported Configuration |
| Workpiece | Large generator stators and rotors |
| Generator Types | Wind, hydroelectric and steam-turbine generators |
| Trolley Load | Up to 300T design capacity |
| Curing Method | Stationary curing or rotating baking/curing configuration |
| Temperature Control | HMI + PLC with PID algorithm |
| Process Recording | Paperless multi-point temperature recorder |
| Electrical Monitoring | Optional programmable insulation resistance tester |
| Remote Monitoring | Industrial control computer / networked monitoring option |
| Safety / Exhaust | Configurable exhaust plus flameproof motor option |
It is designed for large generator stators and rotors used in wind, hydroelectric and steam-turbine generator manufacturing.
The accompanying electric trolley can be designed for a maximum load capacity of 300T.
Yes. A rotating baking/curing configuration can be engineered when the process requires the workpiece to rotate during heating.
A programmable automatic insulation resistance tester can be configured to monitor changes in workpiece insulation resistance during the process.
Choose the HW Series when the workpiece is a large generator stator or rotor and the process requires heavy-load handling, generator-specific airflow, rotating curing or dedicated monitoring. For transformer coils, reactors and instrument transformers, use the dedicated transformer curing oven range instead.
